Question I have one SBB system (SYS-6036ST-6LR). I realized there is no any power cable inside the system for me to provide power output to my SATA DOM. I also noticed that mainboard user manual indicating DOM power output connector ready for user to connect to DOM device. Can you advice which cable is available for me to order? Answer Because the SBB system uses hot-plug design, it does not have 4 pin ATA power connector inside the system. You can have cable, CBL-0141-LH. with some specific DOM brand. Please also check with DOM vendors to see if the design is using 2-pin power input to DOM device. If not, you will need to have this speicific cable from DOM vendors. Most of DOM devices are using 4 ATA power connector and end up with 2 pin power input connector. Was this FAQ helpful? YES      NO Enter Comments Below: Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to support@supermicro.com.  Enter your email address below if you'd like technical support staff to reply:  Please type the Captcha (no space) F G C W FAQ Stats FAQ ID Related Category / Keyword Date Posted Code 11595 Storage: - Hard drives 04/08/11 JML     Print Answer