Question
according to the IPMI documentation you can use ssh to access the modules but there is no detailed information about it.
Print
Answer
These are the ssh commands;

- Show information about the host:
show /system0

- Show information about the BMC:
show /system1

- Read all numeric sensors:
show /system0/nsensor*

- Power up/down/reset the host
start /system0
stop /system0
reset /system0

- Reset the BMC
reset /system1

- Show the SEL:
show /system1/log0
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
H V 8 E
FAQ ID:
9421
Related Category / Keyword:
Hardware Monitoring:
IPMI KVM over LAN SuperDoctor SuperO Doctor II SuperO Doctor III
Date Posted:
03/12/10
Code:
PD
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region