Question
We had set up an SED NVMe with an administrator password in the BIOS.  Unfortunately, we entered the password wrong multiple times and now the drive is locked.  What can we do?
Print
Answer
You can reset the device from the BIOS under Security. 
Select the correct drive under TCG Storage Security Configuration. 
Select Device Reset and enter the drives PSID. 
PSID can be found on the label of the hard drive. 
Please be aware that this will set the drive to its original factory state AND ALL DATA WILL BE ERASED.

If this is a data disk, you can unlock it from the OS, with the correct password.

To unlock a drive with a set locking range, run this command:
# sudo sedutil-cli --disablelockingrange

= Desired size of the locking range (0: Global, 1-15: LRn)
= Admin1 Password
= Target Drive (e.g. /dev/nvme1n1)
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
C H N F
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.