Question
What is the SAA command to update the Raid controller card?
Print
Answer
saa -i -u -p -c UpdateRaidController --file --controller [--type ] --dev_id [--upgrade_only] [{--reboot | --check_reboot_required}]

Example: ./saa -i 192.168.34.56 -u ADMIN -p PASSWORD -c UpdateRaidController --controller Broadcom --type HA-RAID --dev_id 0 -file RAID.rom --reboot

Note:
Supported RAID Controllers
Broadcom: 3108, 3408, 3808, 3808N (AOM-S3808NI-4NM, AOC-SMG4-2M2), 3816, 3908, 3916, 4116
Marvell: SE9230, 88NR2241
Broadcom 3108 RAID controller supports firmware images version 4.650.00-8095 or later.
X12 platforms and newer, the option is mandatory when updating Broadcom controllers.
The Marvell 88NR2241 RAID controller does not support the option because the firmware version cannot be retrieved from the image.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
8 W Y 7
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.