Question
I have a 7042P-8R and one of the four drives always fail on channel B on the backplane, but channel A is fine. It doesn't matter which cable is connected to the SCSI/RAID controller, but follows channel B on the backplane. Is channel B bad?
Print
Answer
This could be caused by a few different reasons: (1) you may need to change the SCSI cable, (2) you may need to change the SCSI backplane, or (3) you may need to update the firmware on the SCSI hard drives.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
V A Q D
FAQ ID:
791
Related Category / Keyword:
Storage:
Adaptec AIC-7902 U320 SCSI
Date Posted:
08/05/03
Code:
Admin
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region