Question
What is port fail over?
Print
Answer
Redundancy between two ports of the same RAID card is defined as port fail over. It requires Firmware, Driver and the management tools to work. It works only w/ E2. It requires SAS HDDs. It operates in the following manner:
1. Plug both ports to E2
2. Create one lun
3. Start stress testing the lun
4. Remove cable from one port and data starts flowing from the other port w/o interruption
5. Plug the cable back in and data still flows w/o interruption
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
C 8 6 D
FAQ ID:
8573
Related Category / Keyword:
Storage:
Backplanes Expanders
Date Posted:
05/05/09
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region