Installing the Rails onto the Rack

  1. Loosen the adjusting screw to allow the rear section to slide in the front section.

  2. Push the small hooks on the front section of the rail into the holes on the front post of the rack and then down, until the spring-loaded pegs snap into the rack holes. Secure the rail to the rack with screws.

  3. Pull out the rear section of the outer rail, adjusting the length until it fits within the posts of the rack and align the small hooks with the appropriate holes on the rear post of the rack. Be sure the rail is level, then mount the rear section onto the rack. Secure the rail with screws.

  4. Tighten the adjusting screw.

Figure 10. Attaching the Rail to the Rack

Important: This figure is for illustrative purposes only. Always install servers to the bottom of a rack first.