Front View
The following features are located on the front of the SYS-822GS-NBRT server.
Figure 1. SYS-822GS-NBRT Front View
|
Expansion Slot Locations |
|
|---|---|
|
Slot |
Description |
| 1 - 8 | PCIe 5.0 x16 LP from PLX Switch linked to GPUs |
| 9 - 10 | PCIe 5.0 x16 FHHL |
|
Drive Bay Locations |
|
|---|---|
|
Bay |
Description |
| 0 - 7 | Eight hot-swap E1.S NVMe drive bays |
| 8 - 9 | Two hot-swap M.2 NVMe drive bays |
Drive Carrier LED Indicators
Each drive carrier has two LED indicators: an activity indicator and a status indicator. For RAID configurations using a controller, the meaning of the status indicator is described in the table below.
|
Drive Carrier LED Indicators |
|||
|---|---|---|---|
|
LED |
Color |
Pattern |
Device Behavior |
|
Activity LED |
Blue |
Solid |
Idle SAS/NVMe drive installed |
|
Blue |
Blinking |
I/O activity |
|
|
Off |
N/A |
Idle SATA drive installed |
|
|
Status LED |
Red |
Solid |
Failure of drive with RSTe support |
|
Red |
Blinking at 1 Hz |
Rebuild drive with RSTe support |
|
|
Red |
Blinking with two blinks and one stop at 1 Hz |
Hot spare for drive with RSTe support |
|
|
Red |
On for five seconds, then off |
Power on for drive with RSTe support |
|
|
Red |
Blinking at 4 Hz |
Identify drive with RSTe support |
|
NVMe SSD LED Indicators
Each E1.S NVMe SSD module has two LED indicators: an activity indicator and a status indicator. For RAID configurations using a controller, the meaning of the status indicator is described in the table below. For OS RAID or non-RAID configurations, some LED indications are not supported, such as hot spare.
|
Rear I/O Ports |
|||
|---|---|---|---|
|
LED |
Color |
Pattern |
Device Behavior |
|
Activity LED |
Blue |
Solid |
Idle SAS/NVMe storage module installed |
|
Blue |
Blinking |
I/O activity |
|
|
Off |
N/A |
Idle SATA drive installed |
|
|
Status LED |
Red |
Solid |
Failure of drive with RSTe support |
|
Red |
Blinking at 1 Hz |
Rebuild drive with RSTe support |
|
|
Red |
Blinking with two blinks and one stop at 1 Hz |
Hot spare for drive with RSTe support |
|
|
Red |
On for five seconds, then off |
Power on for drive with RSTe support |
|
|
Red |
Blinking at 4 Hz |
Identify drive with RSTe support |
|
|
Green |
Solid |
Safe to remove NVMe storage module |
|
|
Amber |
Blinking at 1 Hz |
Do not remove NVMe storage module |
|