Question
I can’t install Red hat 4u5 & 4u6 X64 on the X7QC3 motherboard when the SIMSO+ card is installed If I remove the SIMSO card the installation works fine. What could be the issue?
Print
Answer
Please set [Redirection after BIOS POST] to Disable, this will correct the issue.

[Advanced] -> [Remote Access Configuration] -> [Remote Access] => [Enable] -> [Redirection after BIOS POST]=>Disable
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
M M P 6
FAQ ID:
8273
Related Category / Keyword:
Hardware Monitoring:
IPMI
Date Posted:
11/21/08
Code:
TW
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region