Question
Where is X10Dri-T4 onboard VGA via jumper?
Print
Answer
You may go below link page 14, to see Jumper Setting for JPG1 VGA Enable, and
set JPG1 to Pins 2-3 is to Disable.
https://www.supermicro.com/manuals/motherboard/C600/MNL-1560.pdf
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
T K H L
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region