Question
I have a Promise SC6000 RAID card and put in P4DP6 board. When drives are attached via the RAID card, the system will hang at POST. What causes this issue and how to fix it?
Print
Answer
First, please make sure that you have updated your board's BIOS with the latest version from our Resource Page. Second, please go into BIOS setup, under Advance Setup menu enable PCI slot bus master setting of the PCI slot in which the Promise SX6000 is seated.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
R 8 F N
FAQ ID:
126
Related Category / Keyword:
BIOS:
Phoenix BIOS
Date Posted:
06/23/02
Code:
Admin
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region