Question
For my new twin server with MB X9DRFR, during the install, "on select a disk to install or upgrade", I see two types of disks Local with 186.31 GB and Remote with 2.73 TB. I installed the ESXi on 186.31 GB disk under "Local". Once installation is complete and I reboot the server, my server does not boot from this local disk. When I went to Bios, I don't see anyway to select the local disk in "Boot device order" where I have installed the ESXi.
Print
Answer
In the BIOS setup under BOOT section, please go to Hard Disk Drive BBS and select the “local” drive where EXSi installed so the boot Device will boot from it.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
4 8 L V
FAQ ID:
16318
Related Category / Keyword:
Operating Systems:
Other Operating Systems
Date Posted:
06/07/13
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region