Question
I just updated the IPMI firmware on my X9DRL-iF motherboard from 2.20 to 2.34, but now the sensors are all missing.
Print
Answer
Please look for the JPME1 and JPME2 jumpers located on the motherboard next to the chipset heatsink and the SATA/SCU ports. Remove the AC Power, change it from 1-2 position, to 2-3 to disable it. Then update your BIOS. After the update is finished and the system restarted. Remove the AC power and change the jumpers back to 1-2 to re-enable it. When the system comes back up, the IPMI sensors should show again.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
E K H B
FAQ ID:
16647
Related Category / Keyword:
Hardware Monitoring:
IPMI
Date Posted:
07/24/13
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region