Question
We are facing problems with integrating a 3.5" FDD in your SC811x type chassis. The floppy front panel layout and floppy disk release button do not match. What is the solution?
Print
Answer
This depends on the revision of the SC811x type chassis not being J1 (< j1) revision only supports FPD-PNSC-01. New Revision type SC811x chassis being J1 revision supports FPD-PNSC-01 and FPD-Sony-FB. But, FPD-PNSC-01 is EOL. Please try to get this FDD from the open market. The FPD-Sony-FB is available, but only usable for J1 revision (or later) of the SC811x chassis.
This is how to check the revision of the chassis:

C81100833J00514, is a J0 and only supports FPD-PNSC-01.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
4 D V L
FAQ ID:
8532
Related Category / Keyword:
Other:
Assemble
Date Posted:
01/30/09
Code:
PM
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region