Wall Mounting Procedure

The SYS-212B-LN2T can be mounted directly on a surface using the mounting brackets and mounting screws or nails. The following procedure describes how to mount the server to a sturdy surface. Use screws or nails of sufficient strength to support the weight of the server.

Note: The weight of a fully populated system can reach up to 24.5 lbs or 11 kg.

Mounting the Chassis

1. Attach the two mounting brackets to the server using the four T-pins and two screws for each side. Push the T-pins through the holes in the mounting bracket, highlighted in yellow. Then, secure the M4 screws that came with the server as shown below.

   Note: Images displayed are for illustrative purposes only. The components installed in your system may or may not look exactly the same as the graphics shown in the manual.

   

   Figure 17. Installing the Mounting Brackets

2. Decide on an orientation to mount the server. The server can only be mounted with the I/O panel facing left or right.

   

   Figure 18. Possible Mounting Orientations

3. Mark two keyhole spots on the surface where the server will be mounted. The two keyholes for each orientation are circled in yellow above.

4. Install the two keyhole screws or nails.

5. Mount the server onto the two screws or nails.

6. Install screws or nails in all the holes circled in red above.