Question
I Just purchased a 5017P-TLN4 and install 2 x 8gb PC3 -10600 1333mhz DDR3 SO-DIMM, connected VGA monitor, applied power. Nothing display on monitor, just a quick beep when i hit power button, then just a green light for the power indicator. All LEDS on mother board appear to be correct. Any thoughts?
Print
Answer
Remove all the memory and power on the system board to see is give memory error beep code? If yes then please check your memory and make sure the memory is Un-buffered ECC support. The motherboard does not recommend with 1.5v memory, refer to our memory test list.

http://www.supermicro.com/support/resources/mem.cfm
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
C B A W
FAQ ID:
16287
Related Category / Keyword:
Peripherals:
Memory
Date Posted:
05/31/13
Code:
DL
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region