Question
I downgraded IPMI firmware from IPMI 1.88 to 1.58 on X9SRL-F and some sensor values
are no longer detected. Is there something I can try to get them back?
Print
Answer
Each IPMI firmware version is validated with a specific BIOS revision and it's not
recommended to do downgrades. If for some reason, you cannot use the latest IPMI
firmware version, you can try issuing the following ipmitool raw data commands to erase
unrecognized SDR settings and reset to default factory settings.



Erase unrecognized SDR setting:


ipmitool –H [bmc_ip] –U [username] –P [password] raw 0x30 0x99 0 0 0 0 0 0 0 0 0 0


Reset to default factory setting:


ipmitool –H [bmc_ip] –U [username] –P [password] raw 0x30 0x40
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
C A U 8
FAQ ID:
16812
Related Category / Keyword:
Other:
Firmware/BIOS related Support Information
Date Posted:
08/16/13
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region