Question
We have a new build with system 7046T-6F. This system seems like all power is on, but no video. We do not get any beep codes during post. Any ideas?
Print
Answer
Please turn-off power, unplug AC power, and move the JPG1 jumper to disabled (pins 2,3) for one boot. Power on the system. Wait at least 15 seconds, and then power the system off again, remove AC power and re-enable the JPG1 jumper. Try booting the system once again. You can also do a BIOS clear in the process.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
G Q Q N
FAQ ID:
17005
Related Category / Keyword:
BIOS:
AMI BIOS
Peripherals:
VGA Cards (AGP / PCI / on-board)
Date Posted:
09/13/13
Code:
MDH
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region