Question
I have several fat twin nodes that are using the X10DRFR-NT motherboard. I am testing these nodes with a pair of E5-2600 V4 CPUs to ensure the nodes are functioning correctly. So far I have not installed any other components other than the CPUs and memory. When trying to boot the nodes with two of the CPUs installed they don't post and hang at "PEI--Intel Reference Code Execution. . DC".
If I only install one of these CPUs in CPU1 socket the nodes post without any issues. What can be the cause for this issue?
Print
Answer
Post code "DC" is for configuration error. In general, it is caused by using mismatched CPUs. Please check to ensure that both CPUs are the same model and specifications.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
3 Q M K
FAQ ID:
24459
Related Category / Keyword:
Peripherals:
CPU
Date Posted:
11/18/16
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region