Question
I need to connect my case's front control panel LEDs: HDD LED & PWR LED to X11SCL-LN4F. On your Quick Reference Guide both of these label only one pin each, 14 & 16, the opposite odd pins being labeled UID SW and 3.3V respectively. My case's connector cables each have Positive and Negative connectors. Please advise what to do with the cable Negative connectors.
Print
Answer
Unfortunately it does not support cable negative connectors for front control panel pins, please refer to our website for optimized chassis for X11SCL-LN4F.
https://www.supermicro.com/zh_tw/products/motherboard/X11SCL-LN4F
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
9 C D K
FAQ ID:
32610
Related Category / Keyword:
N/A
Date Posted:
08/17/20
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region