Question
I have an X10DRI motherboard with 6 Seagate ST6000NM0004 6TB hard disks and configured RAID mode in BIOS but after reboot the system, the "CTRL+i" message is not displaying on the screen. So, we tested with (02) 1TB SATA disks using the same steps above. After reboot, the "CTRL + i" is displayed normally.



Do you know something about this issue? For 6TB, is it necessary to configure Raid in UEFI mode? Is this board supports Raid in UEFI mode?
Print
Answer
Seagate ST6000NM0004 is a 4Kn. All X8/X9/X10/X11 Intel onboard controllers, including PCH, ICHxR, do not support 4Kn hard drive.

http://www.seagate.com/www-content/product-content/enterprise-hdd-fam/enterprise-capacity-3-5-hdd/constellation-es-4/en-us/docs/enterprise-capacity-3-5-hdd-v4-ds1791-3-1403us.pdf
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
Y N P K
FAQ ID:
24955
Related Category / Keyword:
N/A
Date Posted:
02/03/17
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region