Question
The manual and motherboard’s definition of the JPME2 jumper appear opposite.
If I jump the JPME2 to 2-3, the system will be restart sometimes automatic. Then I jump it to the 1-2, the system will be boot up right. How to set JPME2 when update BIOS?
Print
Answer
When you update BIOS, set JPME2 to Pin 2-3. After you update the BIOS, BEFORE RESTART, unplug AC, set the JPME2 back to Pin 1-2, THEN re-plug AC to reboot the system.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
H 6 N R
FAQ ID:
25114
Related Category / Keyword:
N/A
Date Posted:
03/03/17
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region