 | | | | |
 | | SYS-1027R-N3RF | - SuperServer 1027R-N3RF (Black)
| | | | | CPU | - Dual Socket R (LGA 2011)
- Intel® Xeon® processor E5-2600
and E5-2600 v2 family†
(up to 130W TDP) | | Note | † BIOS version 3.0 or above is required | | Cache | | | System Bus | | | | | | Memory Capacity | - 16x 240-pin DDR3 DIMM slots
- Up to 1TB DDR3 ECC LRDIMM
- Up to 512GB DDR3 ECC Registered memory (RDIMM)
- Up to 128GB DDR3 ECC and non-ECC UDIMM
| | Memory Type | - 1866/1600/1333/1066/800MHz ECC DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
| | DIMM Sizes | - 32GB, 16GB, 8GB, 4GB, 2GB, 1GB
| | Memory Voltage | | | Error Detection | - Corrects single-bit errors
- Detects double-bit errors (using ECC memory)
| | | | | Chipset | | | SATA | - SATA 2.0 3Gbps with RAID 0, 1, 5, 10
- SATA 3.0 6Gbps with RAID 0, 1
| | SAS | - SAS from C606
- RAID 0, 1, 10 support
| | IPMI | - Support for Intelligent Platform Management Interface v.2.0
- IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
- Renesas SH7757 BMC
| | Network Controllers | - Intel® i350 Dual Port Gigabit Ethernet Controller
- Virtual Machine Device Queues reduce I/O overhead
- Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
- 1x Realtek RTL8211E PHY (dedicated IPMI)
| | Graphics | - G200 (Renesas SH7757 BMC)
| | | | | Serial ATA | - 2x SATA 3.0 ports (6Gbps)
| | SAS | | | LAN | - 2x RJ45 Gigabit Ethernet LAN ports
- 1x RJ45 Dedicated IPMI LAN port
| | USB | - 6x USB 2.0 ports total
(4x rear + 2x via header) | | VGA | | | Serial Port / Header | - 1x Fast UART 16550 port / 1 Header
| | | | |
| | Form Factor | | | Model | | | | |
| | Width | | | Height | | | Depth | | | Gross Weight | | | Available Colors | | | | |
| | Buttons | - Power On/Off button
- System Reset button
- UID button
| | LEDs | - Power status LED
- HDD activity LED
- 2x Network activity LEDs
- Universal Information (UID) LED
| | | | | PCI-Express | - 2 PCI-E 3.0 x16 full-height, Half-length slots
- UIO AOC Compatibility Matrix
(Both CPUs need to be installed for full access to PCI-E slots and onboard controllers. See manual block diagram and AOC Support for details.) | | | |
| | Hot-swap | - 10 Hot-swap 2.5" SAS / SATA HDD trays (connected to onboard storage controller)
| | | |
| SAS/SATA HDD Backplane
(SAS support requires optional SAS controller) | | | |
| | Fans | - 5x 4cm Counter-rotating PWM Fans
| | | |
| | 700W/750W Redundant AC-DC high-efficiency power supply with PMBus and I2C | | AC Voltage | - 700W: 100 - 140 V, 50-60 Hz, 8.5-6 Amp
- 750W: 180 - 240V, 60-50 Hz, 5-3.8 Amp
| | DC Output +5V standby | | | DC Output +12V | - 700W: 58 Amp @ 100-140V
- 750W: 62 Amp @ 180-240V
| | With Power Distributor | - +5V: 25 Amp
- +3.3V: 12 Amp
- -12V: 0.6 Amp
| | Certification |  Gold Certified | | | | | BIOS Type | - 128Mb SPI Flash EEPROM with AMI BIOS
| | BIOS Features | - Plug and Play (PnP)
- APM 1.2
- PCI 2.2
- ACPI 1.0 / 2.0 / 3.0 / 4.0
- BIOS resuce hot keys
- USB Keyboard support
- SMBIOS 2.3
- UEFI
| | | |
| RoHS
| | | Environmental Spec. | - Operating Temperature:
5°C to 35°C (41°F to 95°F) - Non-operating Temperature:
-40°C to 60°C (-40°F to 140°F) - Operating Relative Humidity:
8% to 90% (non-condensing) - Non-operating Relative Humidity:
5% to 95% (non-condensing) | | | |
|  | | |
| | | |
| | | Part Number | Qty | Description | | Motherboard / Chassis | MBD-X9DRW-3F
CSE-116TQ-R700WB | 1
1 | Super X9DRW-3F Motherboard
1U Chassis | | Backplane | BPN-SAS-116TQ | 1 | 10-port 1U TQ (W/ AMI 9072) backplane, support up to 10x 2.5-inch SAS/SATA HDD/SSD | | Cable 1 | CBL-0118L-03 | 1 | Ipass To 4 SATA Cable, 30AWG, 29/29/27/27 CM, W/ 27CM SB, S | | Cable 2 | CBL-0157L-01 | 1 | 8PIN TO 8PIN CABLE FOR SGPIO,615MM,PBF | | Cable 3 | CBL-0230L | 2 | 65CM SATA ROUND S-RA PBF | | Cable 4 | CBL-0287L-01 | 1 | 30AWG, IPASS TO 4 SATA 43/43/33/33CM, W/ 43cm SB, RA | | Riser Card | RSC-R1UW-2E16 | 1 | 1U LHS WIO Riser card with two PCI-E x16 slots | | Heatsink / Retention | SNK-P0047PS | 1 | 1U Passive CPU Heat Sink for X9, X10 Systems Equipped w/ a Narrow ILM MB | | Heatsink / Retention | SNK-P0047PSC | 1 | 1U Passive Front CPU Heat Sink w/ a Side Air Channel for X9, X10 Systems Equipped with a Narrow ILM MB | | Rail Set | MCP-290-00043-0V | 1 set | Rail set for SC113 | | | | |
| | | Part Number | Qty | Description | | Cable for Storage Controller Card Connection | CBL-0343L-01 | 1 | IPASS to 4 SATA Cable, 30AWG 76/66/54/45CM, W/ 66CM | | Rail Set | MCP-290-00063-0N | 1 set | Rail set, quick/quick, for 1U 17.2"W SC113 | | Storage Controller Card(s) | AOC-S3008L-L8e
AOC-S3008L-L8i
AOC-S3108L-H8iR
AOC-S2308L-L8e
AOC-S2308L-L8i
AOC-S2208L-H8iR
AOC-SAS2LP-MV8
AOC-SAS2LP-H4iR
AOC-SAS2LP-H8iR
| -
-
-
-
-
-
-
-
-
| Standard LP, 8 internal ports (12Gb/s) Gen-3, 122HDD, HBA
Standard LP, 8 internal ports (12Gb/s) Gen-3, 63HDD, RAID 0,1,1E
Standard LP, 8 internal ports (12Gb/s) Gen-3, 240HDD, RAID 0, 1, 5, 6, 10, 50, 60
Standard LP, 8 internal ports (6Gb/s) Gen-3, 122HDD, HBA
Standard LP, 8 internal ports (6Gb/s) Gen-3, 63HDD, RAID 0,1,1E
Standard LP, 8 internal ports (6Gb/s) Gen-3, 240HDD, RAID 0, 1, 5, 6, 10, 50, 60
Standard LP, 8 internal ports (6Gb/s) Gen-2, HBA
Standard LP, 4 internal & 4 external ports (6Gb/s) Gen-2, 240HDD, RAID 0, 1, 5, 6, 10, 50, 60
Standard LP, 8 internal ports (6Gb/s) Gen-2, 240HDD, RAID 0, 1, 5, 6, 10, 50, 60 | | Network Card(s) | AOC-SGP-i2
AOC-SGP-i4
AOC-SG-i2
AOC-SG-i4
AOC-STG-b4S
AOC-STGN-i2S
AOC-STG-i2T
AOC-STG-i2 | -
-
-
-
-
-
-
- | Standard LP, 2x GbE RJ45, PCI-E x4, Intel® i350AM2
Standard LP, 4x GbE RJ45, PCI-E x4, Intel® i350
Standard LP, 2x GbE RJ45, PCI-E x4, Intel® 82575EB
Standard LP, 4x GbE RJ45, PCI-E x8, Intel® 82576EB
Standard LP, 4x 10GbE SFP+, PCI-E x8, Broadcom® BCM57840S
Standard LP, 2x 10GbE SFP+, PCI-E x8, Intel® 82599ES
Standard LP, 2x 10GbE RJ45, PCI-E x8, Intel® X540
Standard LP, 2x 10GbE CX4, PCI-E x8, Intel® 82598EB |
| | | |
