 | |
 | | SYS-5015B-M3B | - SuperServer 5015B-M3B (Black)
| | | |
| | CPU | - Single LGA775 ZIF Socket
- Supports Quad-Core Intel® Xeon® X3300/X3200 series
- Supports Dual-Core Intel® Xeon® E3100/3000 series
- Supports Intel® Xeon® processor L3360 and L3110 series
- Supports Intel® Core™2 Quad Q9000/Q8000/Q6000 series
- Supports Intel® Core™2 Duo E8000/E7000/E6000/E4000 series
- Supports Intel® Pentium® E5000/E2000 series
- Supports Intel® Celeron® E1000 and 400 series
- NOTE: Intel Xeon processor L3014 requires an LGA771 socket and is not supported.
| | System Bus | - 1333 / 1066 / 800 MHz system bus
| | | |
| | Memory Capacity | - Four 240-pin DIMM sockets
- Supports up to 8 GB of memory (Dual Channel)
| | Memory Type | - DDR2 800/667MHz unbuffered ECC / non-ECC SDRAM, 240-pin gold-plated DIMMs
| | DIMM Sizes | - 256 MB, 512 MB, 1 GB, 2GB, 4GB
| | Memory Voltage | | | | |
| | Chipset | - Intel 3210 chipset
- ICH9 +2x Intel® 82574L + Broadcom 1068E
| | SAS | - Broadcom SAS1068E
- RAID 0, 1, 10 support
- (Optional: AOC-IButton68) RAID 5 support
| | Serial ATA | - Intel® ICH9 SATA2 (3 Gbps) controller built-in
| | IPMI | - On board IPMI with dedicated LAN
- Support for Intelligent Platform Management Interface v.2.0
- IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
- Winbond® WCPM450
| | Network Controllers | - 2x Single-port Gigabit PCI-Express Ethernet Controllers
- Intel® 82574L
- Supports 10BASE-T, 100BASE-T, 1000BASE-T, RJ45 output
| | VGA | - On-board Winbond® integrated Graphics
| | Super I/O | | | Clock Generator | | | | |
| | SAS | | | Serial ATA | - Two Serial ATA ports (3 Gbps performance)
- Two SATA hard drives supported
| | Floppy | - 1 Floppy controller; 1.44 MB
| | LAN | | | USB | - Up to 8x USB 2.0 / 1.1 compliant ports
- 2 rear ports
- 2 internal headers + 2 on-board
| | VGA | | | Keyboard / Mouse | - PS/2 keyboard and mouse ports
| | Serial Ports | - 1x Fast UART 16550 serial port
- 1x internal header
| | | |
| | BIOS Type | - 8Mb Flash EEPROM with Phoenix ® BIOS
| | BIOS Features | - Plug and Play (PnP)
- DMI 2.3
- PCI 2.2
- ACPI 1.0/2.0
- USB Keyboard support
- Hardware BIOS Virus protection
- SMBIOS 2.3
| | | | |
| | Form Factor | | | Model | | | | |
| | Height | | | Width | | | Depth | | | Gross Weight | | | Available Colors | | | | |
| | Buttons | - Power On/Off button
- System Reset button
| | LEDs | - Power LED
- Hard drive activity LED
- 2x Network activity LEDs
- System Overheat / Fan Fail LED
| | Ports | - 2x Front USB Ports
- 1x Serial COM Port
| | | |
| | Hot-swap | - 4x 3.5" SAS Hot-swap drive bays
| | | |
| | Fans | | | | |
| | 280W AC power supply w/ PFC | | AC Voltage | - 100 - 240V, 50 - 60Hz, 5Amp
| | +5V | | | +5V standby | | | +12V | - 23Amp @ 100-140V, 27Amp @ 180-240V
| | -12V | | | +3.3V | | | | |
| | CPU | - Monitors for CPU Cores ( +1.8V, +3.3V, +5, ±12V, +3.3V Standby, +5V Standby, VBAT, HT, Memory, Chipset)
- CPU Core 4-Phase-switching voltage regulator with auto-sense from 0.3750V-1.6000V
- Adjustable CPU clock frequency ratio
| | FAN | - Total of six 4-pin fan headers
- 6x fans with tachometer monitoring
- Status monitor with firmware / software speed control
- Status monitor for on/off control
- Support 3-pin fans (without speed control)
- Low noise fan speed control
- Pulse Width Modulated (PWM) fan connector
| | Temperature | - Monitoring for CPU and chassis environment
- CPU Thermal Trip support
- Thermal Monitor (TM2) Support
- PECI
| | LED | - CPU / System Overheat LED
- +5 Standby alert LED
| | Other Features | - Chassis intrusion detection
- Chassis intrusion header
| | | |
| | Environmental Spec. | - Operating Temperature: 10°to 35°C (50°to 95°F)
- Non-operating Temperature: -40°to 70°C (-40°to 158°F)
- Operating Relative Humidity: 8% to 90% (non-condensing)
- Non-operating Relative Humidity: 5 to 95% (non-condensing)
| |
