Question
Do you have a Solaris build or a command set I can send using ipmitool that replicates the reset command?
Answer
In ipmitool, please use the following RAW command to reset the IPMI to factory defaults (this is not the same as a cold reset, that's #ipmitool mc reset cold).

#ipmitool raw 0x3c 0x40
Was this FAQ helpful?
YES      NO

Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to support@supermicro.com.



 Enter your email address below if you'd like technical support staff to reply:


 Please type the Captcha (no space)
C P E G

FAQ Stats
FAQ ID Related Category / Keyword Date Posted Code
15448 Hardware Monitoring:
- IPMI
01/14/13


    Print Answer