Question Our SuperServer 5018A-FTN4 always Stuck On B0, whole system from Supermicro with 2 memory modules on the package is (HMT41GS6BFR8A-PB / 2 x 8GB PC3L-12800s), any suggestion ? Answer It's memory SPEC difference issue, your memory module : HMT41GS6BFR8A-PB, Hynix 8GB PC3-12800 1600MHz 204pin Laptop / Notebook SODIMM CL11 1.35V (Low Voltage) Non-ECC DDR3 Memory. Please note that the A1SRi-2758F motherboard supports up to 32GB of ECC DDR3-1600/1333 SO-DIMM memory. You may also check Supermicro website for a list of memory modules that have been validated with the A1SRi-2758F motherboard. http://www.supermicro.com/products/system/1U/5018/SYS-5018A-FTN4.cfm Was this FAQ helpful? YES      NO Enter Comments Below: Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to support@supermicro.com.  Enter your email address below if you'd like technical support staff to reply:  Please type the Captcha (no space) N 9 D D FAQ Stats FAQ ID Related Category / Keyword Date Posted Code 22707 Peripherals: - Memory 03/18/16     Print Answer