Network Configuration Menu
Network Stack
Select Enabled to enable Preboot Execution Environment (PXE) or Unified Extensible Firmware Interface (UEFI) for network stack support. The options are Disabled and Enabled.
IPv4 PXE Support (Available when "Network Stack" is set to Enabled)
Select Enabled to enable IPv4 PXE boot support. If this feature is disabled, it will not create the IPv4 PXE boot option. The options are Disabled and Enabled.
IPv4 HTTP Support (Available when "Network Stack" is set to Enabled)
Select Enabled to enable IPv4 HTTP boot support. If this feature is disabled, it will not create the IPv4 HTTP boot option. The options are Disabled and Enabled.
IPv6 PXE Support (Available when "Network Stack" is set to Enabled)
Select Enabled to enable IPv6 PXE boot support. If this feature is disabled, it will not create the IPv6 PXE boot option. The options are Disabled and Enabled.
IPv6 HTTP Support (Available when "Network Stack" is set to Enabled)
Select Enabled to enable IPv6 HTTP boot support. If this feature is disabled, it will not create the IPv6 HTTP boot optiont. The options are Disabled and Enabled.
PXE Boot Wait Time (Available when "Network Stack" is set to Enabled)
Use this feature to set the wait time (in seconds) upon which the system BIOS will wait for you to press the <ESC> key to abort PXE boot instead of proceeding with PXE boot by connecting to a network server immediately. Press the <+> or <-> key on your keyboard to change the value. The default setting is 0.
Media Detect Count (Available when "Network Stack" is set to Enabled)
Use this feature to set the wait time (in seconds) for the BIOS ROM to detect the presence of a LAN media either via the Internet connection or via a LAN port. Press the <+> or <-> key on your keyboard to change the value. The default setting is 1.
Interface Name
Interface Type
MAC address
Host addresses
Route Table
Gateway addresses
DNS addresses
Interface ID
DAD Transmit Count
The number of consecutive Neighbor Solicitation messages sent while performing Duplicate Address Detection on a tentative address. A value of zero indicates that Duplicate Address Detection is not performed. The default value is 1.
Policy
Use this feature to select how the policy is to be configured. The options are Automatic and Manual.
Save Changes and Exit
The options are Yes and No.
Enable DHCP
The options are Disabled and Enabled.
Local IP Address
Enter IP address in dotted-decimal notation. Example: 192.168.10.12
Local NetMask
Enter NetMask in dotted-deimal notation. Exmaple: 255.255.255.0
Local Gateway
Enter Gateway in dotted-decimal notation. Example: 192.168.10.1
Local DNS Servers
Enter DNS Servers in dotted-decimal notation. Example: 192.168.10.8
Save Changes and Exit
The options are Yes and No.