X7DWU BIOS release note
------------------------------------------------------------------
7DWU4308.ROM	Date:04-30-2008			ver 1.1
1. Add IPMI IP/MAC setting in BIOS setup memory
 Description: User can change IPMI IP and MAC address in BIOS setup 


2. Update Intel ESB2 AHCI option ROM from v112E to v117D
 Description: Fixed 2 bugs that resulted fail to boot to ODD in Port1 and beyond. 


3. Remove unnecessary I2C data in OS loading
 Description: BIOS would check h/w monitor regeistor data in ACPI OS loading, 
 but it is not necessary for current motherboard


4. Correct DMI information for BIOS and PCIe slots
 Description: Some define in BIOS DMI data and PCIe DMI data is not exact


5. Fix system cannot enter BIOS setup ATI MV2400 video card
 Description: There was no screen after POST98



------------------------------------------------------------------
7DWU4028.ROM	Date:04-02-2008			ver 1.0a
1. Fix OS install slow with 64G above memory
 Description: MTRR entries were missed


2. Add SMRR feature for Harpertown/Wolfdale-DP
 Description: New security feature in Intel new Harpertown/Wolfdale-DP


3. Fix correctable ECC error logging cannot work
 Description: SMI log handler was not correctly hooked
 
4. Fix IPMI driver cannot be installed in Linux
 Description: DMI type38 (IPMI interface) is not correct. Linux driver is 
 based on this information
 

5. Update Intel ESB2 AHCI option ROM
 Description: from v108 to v112E
 

6. Fix customer SLP cannot be added with Plogo
 Description: The SLP address is shift in new BIOS kernel. Some code is to be 
 changed correspondingly
 
7. Fix option ROM scan fucntion cannot work properly with bridge 
device
 Description: The bus number is shift if there is a bridge device plugged in. 
 

8. Fix performance of bottom slot of riser is too low with Gen1 PCIe card
 Description: Fine tune the signal stress of this slot 
 


------------------------------------------------------------------
7DWU2048.ROM	Date:02-04-2008			ver 1.0
1. Update Harpertown/Wolfdale-DP CPU microcode (P69)

2. Change CPU temperature offset settings.


------------------------------------------------------------------
7DWU1288.ROM	Date:01-28-2008			ver 1.0
1. Enable IPMI KVM function for PCB1.01. (IPMI USB port is changed to Port#6)

2. Update Intel ESB2 RAID from 5.6.2.1002 to 5.6.4.1002

3. Remove KB power on function for no standy 5V to PS2. 

4. Update code for SATA Tape drive support

5. Fix IRQ error in SXB2.

6. Change Flow Contorl from CTS/RTS to None when IPMI Console Redirection is 
enabled

7. Use CPU MSR to re-calibrate CPU PECI temperature offset


------------------------------------------------------------------
7DWUC217.ROM	Date:12-21-2007			ver 1.0

1. Bring up version.

2. Update MRC from v1.00 to v1.10RC

3. Fix system sometimes hang at early stage with certain CPU
