Question
We have a X11DDW-NT based system that we recently purchased the NVME cables and kit to install four Kioxia CD7 NVME drives.  We created the 4-disks RAID10 successfully, but in Windows it shows the RAID10 failed.
Any idea how to troubleshoot it?
Print
Answer
You can try to boot the system up using Rocky Linux 9.6 and check the dmesg log for the nvme drives.  If the drives were migrated from other systems, chances are the RAID metadata might not completely cleaned.
Clean the drives and recreate RAID10 in BIOS.
# for i in {0..3}; do dd if=/dev/zero of=/dev/nvme${i}n1 seek=$(($(blockdev --getsz /dev/nvme${i}n1)-5))
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
M K L W
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region