Question
Should I be concerned about the following sensor
name changes for BMC 1.07.09 or later versions in X12SPT-PT?

MB 12V à 12V<o:p></o:p>



MB 5 VCC à 5 VCC<o:p></o:p>



MB 3.3 VCCà 3.3 VCC<o:p></o:p>



MB 3.3 VSB à 3.3 VSB<o:p></o:p>



PCH 1.8V à 1.8V PCH<o:p></o:p>



PCH PVNN à VNN PCH<o:p></o:p>



PCH 1.05V à 1.05V PCH<o:p></o:p>



BMC 2.5V à 2.5V BMC<o:p></o:p>



BMC 1.8Và 1.8V BMC<o:p></o:p>



BMC 1.2Và 1.2V BMC<o:p></o:p>



BMC 1.0V à 1.0 BMC<o:p></o:p>

Print
Answer
No, the BMC adopts a new version of the sensor specification, which causes some sensor names to differ from the previous
version. However, the functionality is not affected
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
4 E A 8
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region