I recently purchased the X10SLM-F after power on will hang at System initializing code91, please help advice to solve this.
Base on the Postcode 91, please refer followings procedures to clean CMOS.
A. Disconnect the AC power cord.
B. Remove internal CMOS battery.
C. Find JBR1 solder pad and short contact about 5 to 10 second.
D. Re-insert the CMOS battery.
E. Re-connect AC power cord.
F. Power On system board and enter to CMOS setup.
G. Press F3 Load Restore Optimal save change and exit to reboot.
Print
Share