Question
I have one of your motherboards that support ATA100, when I connect an ATA100 drive, it is detected as ATA33. What could be wrong?
Print
Answer
Please make sure you are using an 80-pin ATA100 IDE cable; if you use a ATA33 IDE cable then the drive will be limited to this protocol. Also make sure that the blue connector must be connected to motherboard not the drive.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
B M X V
FAQ ID:
467
Related Category / Keyword:
Storage:
Hard drives
Date Posted:
02/03/03
Code:
Admin
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region