Question
This new SC836E2 chassis has the three fans in front of the backplane connected to FAN2, FAN3, FAN4. When I turn the system on it starts all three fans but after about 4-5 seconds the alarm sounds. The fan fail LED on the board lights up and stays on even though the fans are running. Once the OS boots up the event viewer reports fail fans 1,2, and 3. I don’t want to just disable the alarm. Is there possibly a jumper related problem although I have not changed any or a firmware issue?
Print
Answer
If you have LSI 8888ELP controller, you have to disable the “Maintain PD fail history” in the controller properties, the problem will goes away.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
W G H T
FAQ ID:
8853
Related Category / Keyword:
Peripherals:
Cooling Fans
Date Posted:
04/17/09
Code:
DL
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region