Question
i have a problem with the IPMI on the X10SLH-F Mainboard.
If i changed the "Lan Interface" from default "Failover" to "Share" or "Dedicate" the IPMI Webinterface is unreachable.
In the System BIOS the "ipmi network link status" is "no connect" and the "ipmi lan selection" shows "share lan".
All three NIC´s (Dedicated IPMI, NIC 0 and 1) are connected to the network, but the Webinterface is unreachable.

After a reset to factory default over ipmicfg the module again reached.

I test it with firmware 00.26 and 01.07. It´s with both versions the same problem.

In addition, if the "Lan Interface" workes with "Failover" (Network Link Status > Active Interface > Dedicated) and i remove the network cable from the dedicated NIC the Webinterface is unreachable although NIC0 is connected.

Is there a newer firmware which fix this problem?
Print
Answer
The problem may not relate IPMI firmware, can you request latest version EEPROM from Tech support and flash it.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
F 7 R C
FAQ ID:
16496
Related Category / Keyword:
Hardware Monitoring:
IPMI
Date Posted:
07/04/13
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region