Question
I newly installed your P4DMS-6GM. Although the CPU and memory are okay, I do not get picture.
Print
Answer
Please make sure the jumper on JP39 is on 2-3 (400MHz FSB), and not at 1-2 (Auto), this jumper is to set FB but is not mentioned in your manual, you can find the jumper on the left hand side next to CPU2.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
M 3 4 E
FAQ ID:
576
Related Category / Keyword:
N/A
Date Posted:
04/04/03
Code:
PM
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region