Installing a Processor Heatsink

Notes: 

  • The installation described in this section is for reference only. The actual installation steps may vary depending on the CPU heatsink model. Refer to the heatsink instructions for more details.

  • Images displayed are for illustration purposes only. Your components might look different from those shown in this manual.

  1. Loosen four screws to release the backplate. Note that one screw is not shown in the illustration below.

    Figure 15. Release the Backplate from the Heatsink

  1. If there is a thin layer of protective film on the backplate, remove it.

    Figure 16. Remove the Protective Film

  1. Attach the backplate into the mounting holes around the processor socket on the bottom side of the motherboard.

    Figure 17. Attach the Backplate to the Bottom Side of the Motherboard

  1. Apply the proper amount of thermal grease on the processor.

    Figure 18. Apply Thermal Grease

  1. Place the heatsink on top of the processor so that the four mounting holes on the heatsink are aligned with those on the retention mechanism.

  2. Tighten the screws.

    Figure 19. Tighten the Heatsink Screws