Question
"We found when use different load bios to default methods will have different result on C2G41 MB. TPM shows Enable/Disable when automatically load default but shows ""no state"" when manually load default. Is it a BIOS issue?
BIOS: C2G41OC0.823
PCB: Rev1.01"
Print
Answer
"The reason why there's difference between 2 methods is because automatically load default will reboot after load default.
Automatically:
Load default in DOS mode, if you want to see BIOS setup screen, you have to reboot and press DEL.
During reboot, BIOS will detect TPM status and show the status, which is Enable/Disable.
Manually:
After load default, system not reboot yet, BIOS cannot detect the status of TPM so it shows “No State”
Once you reboot, you can see the status changed to be “Enable/Disable”.
This is normal symptom."
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
Q V B 6
FAQ ID:
10773
Related Category / Keyword:
N/A
Date Posted:
10/22/10
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region