Question
I installed SATA HDDs on 6016T-GIBQF; I setup Adaptec RAID1 on SATA #0 and SATA #1, and made SATA #2 as simple volume. But SATA #2 fails; LED is always blinking in Windows 2008. Is the backplane broken?
Print
Answer
Please make sure the SGPIO cable is connected to T-SGPIO-0 connector, not T-SGPIO-1.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
U R 3 4
FAQ ID:
14161
Related Category / Keyword:
Other:
LED
Date Posted:
05/03/12
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region