Question
I have a 6017R-TDF and I updated the BIOS to 1.0b and the IPMI firmware to 1.78. Now the IPMI sensors are all gone in the web browser. I read the other FAQs and tried clearing the browser's cache, and then the Java's cache, and even cleared the CMOS but the sensors don't show up. What should I do now?
Print
Answer
Since IPMI reads the sensor information from the BIOS, if you flashed the BIOS before you updated the IPMI firmware, you will need to flash the BIOS again. Most likely the first time the BIOS was flashed incorrectly or didn't reset properly, so IPMI couldn't read the sensor information.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
L T W C
FAQ ID:
15111
Related Category / Keyword:
Hardware Monitoring:
IPMI
Date Posted:
11/12/12
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region