Question
I have 5086B-TRF system. All 4 blades work fine and are tested in slot 1 alone. They all POST and are able to go into the BIOS showing correct amount of RAM and CPU. When I populate slots 1 & 2 it works fine (with or without bridge). But when I put a blade in slot 3 it doesn’t POST, even though the blade inside that slot is good.
Print
Answer
5086B-TRF system is optimize for 4 CPU (4-way) or 8 CPU (8-way). Please install motherboard either slot1 and slot2 or slot1, slot2, slot3 and slot4. Installation motherboard on this combination slot1, slot2 and slot3 or slot1, slot2 or slot4 is not recommended.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
U K B B
FAQ ID:
12711
Related Category / Keyword:
N/A
Date Posted:
09/16/11
Code:
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region