Category:  Storage Keyword:  SAS 520 FAQs Found PAGE  1   2   3   4   5   6   7   8   9   10   11   12   13   14   15   16   17   18   19   20   21   22   23   24   25   26   27   28   29   30   31   32   33   34   35   36   37   38   39   40   41   42   43   44   45   46   47   48   49   50   51   52  OF 52    Question Date 1 We purchased a new server 121H-TNR and we need to RAID 8 SAS drives in the front drive trays. What controller can we use? 04/12/24 2 How many drives are supported in front drive bay of Hyper system SYS-621H-TN12R with RAID Controller AOC-S3916L-H16iR-32DD? 02/23/24 3 We are looking at purchasing the SYS-120TP-DTTR. Can we add a hardware controller with IT or JBOD mode to the system? 02/16/24 4 We need to install 4 SAS drives without RAID in the server 511E-WR. What would be the recommended parts? 01/05/24 5 With S3008 SAS Controller card on X11DAC, the drives won't authorize /unlock a SED enabled disk during boot.  If the same unlock script is run after the system is fully booted, the drives unlock without issue. Looking through logs, we see the following error: “The running kernel lacks CONFIG_IDE_TASK_IOCTL support for this device.”  12/01/23 6 We have an older AOC-SASLP-MV8. Where is the Windows driver for this card? 11/10/23 7 We installed the X12Dpi-N6 into chassis LA26E1C4-R609LP. Which RAID controller can we use to connect with the SAS drives in the front of the chassis? 10/20/23 8 We have an AOC-S3008L-L8E+ in the system 8049U-E1CR4T, and we need a long enough cable to reach the backplane. What cable would you recommend? 10/06/23 9 We are using a head node with the LSI/Broadcom controller 9380-8e connected to a JBOD and the JBOD was powered-down for a while. When the JBOD came back, it showed as all the drives showed as Un-configured Bad. How can we get the drives back? 07/28/23 10 We have system 540P-E1CTR36H with AOC-S3908L-H8iR. Can we set this card to pass-through instead of RAID? 07/07/23