Question
We have an older X6DH8-XG2 that will not post. It does get the memory beep code when memory is removed. The memory tests are ok in another system. Is there any other test we can try?
Print
Answer
Please unplug the AC power. Change the JPG1 jumper to pins 2 and 3. Then connect power and turn on. You will hear no video beep code. Unplug the system again, but this time move the JPG1 jumper back to pins 1, 2. Reconnect power and make sure your memory is installed. This time you should get video post back.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
8 R H Y
FAQ ID:
11544
Related Category / Keyword:
Peripherals:
VGA (PCI-e) VGA Cards (AGP / PCI / on-board)
Date Posted:
03/25/11
Code:
MDH
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region