Question
I can't get the PDSME+ motherboard to post on power-up. The motherboard is installed in a Super Chassis 836TQ-R800. The only error I receive is the red temp light on the chassis flashing at startup. After a moment or two the motherboard makes a faint beeping. What could be the issue?
Print
Answer
The symptom could be cause by the power supply and processors. Check the following.
1. Make sure 24pins ATX power and 8pins or 4pins EP12V power is connect to motherboard.
2. Reset the processor and make sure CPU socket does not have any bend pins.
3. Check the processor and make sure is 1066MHz/800MHz/667MHz FSB.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
U T C W
FAQ ID:
9254
Related Category / Keyword:
Other:
Assemble
Date Posted:
07/17/09
Code:
DL
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region