Question
My server is 6027R-TRF. I just replaced one of bad hard drive with Seagate hard drive ST3300657SS. After that we are facing an issue the HDD 0 LED continuously glowing. The LED sloid is happening on ST3300657SS only. Any idea?
Print
Answer
The Active LED stays on symptom should relate to the Seagate ST3300657SS itself. A similar case has been posted on Seagate forum to deal this known issue http://forums.seagate.com/t5/Savvio-Cheetah-and-Constellation/ST3300657SS-Activity-LED/m-p/129744
Please try set RLM bit to 1 first using sdparm utility and follow the instruction in the Seagate forum, or contact Seagate support to get suggested firmware and upgrade instruction.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
B W K G
FAQ ID:
16116
Related Category / Keyword:
Other:
Support Information
Date Posted:
05/03/13
Code:
JKL
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region