Question
One blade will boot and install Xen Server ok, but when I enabled “Intel Virtualization Technology” it constantly reboots and will not load XenServer. I am able to get it to boot by disabling the “Virtualization” option in the bios or by booting xen with the “nosmp” option. However this method does not allow me to run virtual clients on the blade so it is unusable. I have tried updating the bios to the latest version without any luck.

The second blade freezes at the post screen.

Let me know what I need to do to resolve the two issues with these blades.
Print
Answer
There is a chance that you have a bad stick of ram and processor. Please verify it first.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
V 7 B R
FAQ ID:
9557
Related Category / Keyword:
Feature:
Intel Virtualization Technology (Intel VT)
Date Posted:
04/13/10
Code:
JC
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region