Question
We ran into a few issue when trying to measure the throughput of the FDR infiniband network between servers with X9DRT-HIBFF motherboard inside. At this point or old QDR infiniband configuration out performs this test environment. Inconsistent speed when using iperf speed drops off with repeated runs both in datagram and connected modes. I also want to know if there’s any way we can verify that these cards are FDR and not QDR because I’m seeing then connect at 40 gigs. FYI, the firmware is rev 2.10.630. I have tried various Linux distro’s just to rule out and make sure that it’s not a kernel driver issue.
Print
Answer
Please contact Supermicro Tech Support (support@supermicro.com) for firmware v2.10.700 released in April 2012 to upgrade the Infiniband firmware.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
E B X R
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region