Question
How can I connect the 50-pin SCSI ribbon cable into P4DC6+II motherboard?
Print
Answer
Since the connector is parallel to the board's surface, you'll need to hold the data ribbon cable against the 50-pin SCSI connector at 45-degree angle and then push IN and DOWN at the same time.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
3 C C 8
FAQ ID:
135
Related Category / Keyword:
Storage:
Adaptec 2000S / 2005S U160 SCSI ZCR card Adaptec AIC-7899 U160 SCSI
Date Posted:
06/23/02
Code:
Admin
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region