Question
I am using P4SGE/R board with NT4.0 Workstation. However, both LANs cannot get IP addresses through DHCP after the driver is installed. What causes this issue?
Print
Answer
Due to the fact that NT4.0 Workstation does not support Hyper-threading, you need to:

1. disable APIC (under advanced BIOS setup menu) in order for gigabit LANs to work properly or

2. update your system BIOS with the latest verion available on our web (rev. 1.0a or newer)
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
N 4 E P
FAQ ID:
295
Related Category / Keyword:
Networking:
NIC (on-board / add-on)
Operating Systems:
Windows 2000 / Windows NT
Date Posted:
11/03/02
Code:
Admin
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region