Question
I installed a PCI LAN card in P4SDA+. How can I have WOL function work?
Print
Answer
To setup WOL, please make sure you have the followings:

1. The NIC must support WOL feature. P4SDA+ is PCI 2.2 compliant. If the card is not PCI2.2 compliant, then it must have a WOL cable to connect to the onboard WOL header. If the card is PCI2.2 compliant, you should not need the WOL cable.

2. The power supply must provide enough 5V standby power.

3. If the NIC card is ok, boot up the system and enter BIOS setup. In Power Management section, set "Wake up on LAN" and " Wake up by PCI card" to Enabled, then save new setting.

4. Make sure that you have the newest LAN driver to support WOL in Windows.
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
3 T 9 R
FAQ ID:
402
Related Category / Keyword:
Networking:
NIC (on-board / add-on)
Peripherals:
WOL(Wake-On-LAN)
Date Posted:
01/03/03
Code:
Admin
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region