Question
We have the board X8DT6-F and a drive to the SAS2008 onboard for back-up.The OS is Win 2008 R2 64-bit. We are getting an error code 10, device fails to start, in the device manager. What could be the problem?
Print
Answer
Please make sure you are using phase 10 or later of the SAS2008 IR firmware. The firmware can be downloaded from our FTP site at this location.
https://www.supermicro.com/wdl/driver/SAS/LSI/2008/IR/Firmware/PH10.0/Non_Blade/PH10.zip
Was this FAQ helpful?
Enter Comments Below:
Note: Your comments/feedback should be limited to this FAQ only. For technical support, please send an email to .
Enter your email address below if you'd like technical support staff to reply:
Please type the Captcha (no space)
7 X Y W
FAQ ID:
13110
Related Category / Keyword:
Storage:
SAS RAID
Date Posted:
11/18/11
Code:
MDH
Find more questions
Still Need Support?
Having trouble finding what you're searching for? Contact our support team for further assistance.

Certain products may not be available in your region